Uddin, Dr. JiaKhan, Tanzim AhmedSamiu, Mohammad Samiul HaqueSani, Md. ShahabuddinHaque, Md. Mozammel2018-02-152018-02-15201712/24/2017ID 12121083ID 11301010ID 11321060ID 12121140http://hdl.handle.net/10361/9482Cataloged from PDF version of thesis.Includes bibliographical references (page 32-33).This thesis report is submitted in partial fulfilment of the requirements for the degree of Bachelor of Science in Electrical and Electronic Engineering, 2017.The expansion in the fast development of innovation altogether expanded the use and usage of CNC machines yet is costly. This paper examines the outline viewpoints and machinability investigation of low cost CNC machine cum engraver which is fit for 3-axis synchronous operation with less complexity. The additional Bluetooth highlight makes the machine more easy to use to work utilizing a cell phone separated from USB.The lower cost is accomplished by interfacing standard PC with micro controller based CNC framework in an Arduino based embedded system. After the completion of machining, experimental trials to define machining parameters were held. The purpose of the Self-Guided CNC project is to construct a functional CNC type machine capable of tracking lines on and object to guide the armature in cutting the piece correctly. The device would be capable of functioning independent of off-board computers for both operation and determining cutting paths. The goal is not only high-precision cuts but also design and plot.33 pagesenBRAC University thesis is protected by copyright. They may be viewed from this source for any purpose, but reproduction or distribution in any format is prohibited without written permission.CNC machineMicro-controller3 AxisThesis